Operating Instruction BX 3-BT (02)

*2209577*
2209577 English 7
Status Meaning
The LED flashes green every 3 seconds. The fastening tool is in stand-by mode. Press the
nose of the tool against the working surface to
switch it on
The LED flashes steadily green. The fastening tool is too hot or the battery has in-
sufficient power; see “Troubleshooting”
The LED flashes red. Malfunction; see “Troubleshooting”
The LED shows red. Malfunction; see “Troubleshooting”
The LED flashes yellow. Bring the fastening tool to Hilti Service.
3.5 Indication of battery charge status
When one of the battery release buttons is pressed, the display indicates the battery’s state of charge.
Reliable indication of the charge status is not possible while a fastener is being driven or immediately
after a fastener is driven.
Status Meaning
All four LEDs show green. Charge status is 75 % to 100 %.
Three LEDs show green. Charge status is 50 % to 75 %.
Two LEDs show green. Charge status is 25 % to 50 %.
One LED shows green. Charge status is 10 % to 25 %.
One LED flashes green. Charge status is below 10 %.
3.6 Items supplied
BX 3-BT fastening tool, XFG B3 series fastener guide, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4 Technical data
4.1 Fastening tool
Weight including battery B 22/2.6 Li-Ion (02)
4.0 kg
(8.8 lb)
B 22/3.0 Li-Ion (01)
4.1 kg
(9.0 lb)
B 22/4.0 Li-Ion
4.2 kg
(9.3 lb)
B 22/5.2 Li-Ion (01)
4.3 kg
(9.5 lb)
B 22/8.0 Li-Ion
4.6 kg
(10.1 lb)
Threaded-stud length
31 mm
(1.2 in)
Thread diameter
8 mm … 10 mm
(0.3 in … 0.4 in)
Compression stroke
12 mm
(0.5 in)
Contact pressure
50 N … 70 N
(11 lb
f
… 16 lb
f
)
Application temperature (ambient temperature)
−15 ℃ … 50 ℃
(5 ℉ … 122 ℉)