WSR 1000 325932 *325932* D GB F I S Bedienungsanleitung Operating instructions Mode d’emploi Istruzioni d’uso Bruksanvisning 1– 6 7–12 13–18 19–24 25–30
1
2 3 min.40mm 4 min.40mm 5 6 8 max.
9 10 11
WSR 1000 reciprocating saw General information It is essential that the operating instructions are read before the tool is operated for the first time. In these operating instructions, this symbol indicates points of particular importance to safety. The instructions at these points must always be observed in order to avoid the risk of serious injury. Caution: high voltage Always keep these operating instructions together with the tool.
Main features of the tool Class II electrical protection (double insulated) Z (as per EN 50144) Anti-vibration system (additional operator protection) Mechanical slip clutch (additional gearing protection) Vibration-absorbing grip Keyless blade clamp Saw blade inversion possible Keyless contact shoe adjustment Infinitely variable stroke rate preselection with speed control switch Right of technical changes reserved The tool is designed for the following uses Applications Cutting wood Cutting metal Demol
Safety precautions When using electric tools, the following fundamental safety precautions must always be observed in order to avoid the risk of injury, electric shock and fire hazards. Please read and observe the instructions below before using the tool. 1. Use protective equipment. Wear ear protection Wear goggles Wear protective gloves Wear respiratory protection when the work causes dust 2. Wear suitable working clothing.
Failure to observe this point may result in damage to the tool or present a risk of accident. Accordingly, if necessary, have the tool repaired at a Hilti service centre or authorised Hilti repair workshop. 12. Always wear protective gloves and suitable protective goggles when working as saw blades may break or splinter. Use clamps or a vice to hold the work. It is safer than using your hand and it frees both hands to operate the tool.
Plunge sawing The plunge sawing technique should be used only on soft materials and when the orbital action is switched off. A little practise is required in order to be able to plunge the blade into the material while the saw is running and thus make cut-outs without first drilling a hole. Plunge sawing is possible only with short saw blades. Plunge cuts may be started with the saw in one of two different positions: in the normal position or in the reversed position .
Disposal Most of the materials from which Hilti power tools are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back your old electric tools for recycling. Please ask your Hilti customer service department or Hilti sales representative for further information.
Konformitätserklärung Dichiarazione di conformità CE Bezeichnung: Säbelsäge Typenbezeichnung: WSR1000 Konstruktionsjahr: 2000 Wir erklären in alleiniger Verantwortung, dass dieses Produkt mit den folgenden Richtlinien und Normen übereinstimmt: EN 55014-1, EN 55014-2, EN 50144-1, EN 50144-2-11 gemäss den Bestimmungen der Richtlinien 73/23/EWG, 89/336/EWG und 98/37/EWG Designazione: Seghetto frontale Modello: WSR1000 Anno di costruzione: 2000 Dichiariamo, con nostra unica responsabilità, la conformità di q
Hilti = registered trademark of Hilti Corp., Schaan W 0000 0300 00-Pos. 1 1 Printed in Liechtenstein © 2000 Right of technical and programme changes reserved S. E. & O. 325932/A Hilti Corporation Headquarters FL-9494 Schaan Tel.: +423 / 236 2111 Fax: +423 / 236 29 65 www.hilti.
