User's Manual

141
“End time” is the fourth field in the “Add Schedule” dialog box. Here
you can set the time when the appointment ends. By default, the same
time as the time you set in the “Start time” field is displayed. If you
want to change the time, type the time as you would in the “Start time”.
You should refer to “7.3 Set time and date” for more details about how to
enter the time. After setting the time, press “tab (“Space-4-5”)” to move
to the next field. If you press “Enter” by accident right after entering the
time, you will get the message, “no subject”, and then the focus moves
to the “Subject” field.
7.4.5 Subject
“Subject” is the fifth field where you can type in the subject of an
appointment. If you do not enter anything in this field, you will not be
able to save the record. If you press “Enter” after typing in the subject,
the record will be saved, leaving the “Location” and “Memo” field empty,
and the “Alarm time” field set to its default value (“Time of appointment”).
If you want to move to the next field, press “tab (“Space-4-5”)”, instead of
“Enter”.
7.4.6 Location
In the “Location” field, you can type appointed location. If you press
“Enter” after typing in the location, the record will be saved, leaving the
“Memo” field empty, and the “Alarm time” field set to its default value
(“Time of appointment”). If you want to move to the next field, press “tab
(“Space-4-5”)”, instead of “Enter”.
7.4.7 Memo
In the “Memo” field, you can enter detailed information about an
appointment. Here, you can type in more than one line. You can use
most of the editing commands that are used in the “Word processor”.
Press “Enter” to enter information on a new line. You can leave this field