User's Manual

313
14. Press “Enter”. Windows will then begin exchanging the passkeys,
and a new dialog will appear on the computer.
15. The Braille Sense OnHand will then ask for the passkey by saying,
“Computer Edit Box PIN code:” Using the same passkey that was
typed in to the computer, type in the same passkey on the Braille
Sense OnHand and press “Enter” on the Braille Sense OnHand.
16. The computer will say the message, “Found new hardware” and the
final dialog should appear on the computer. Remember that you can
press “ctrl-shift-w” to have the entire dialog read using Window-Eyes.
The dialog should display that the Bluetooth device was successfully
set up. It is very important to note the COM ports for the outgoing
COM port and the incoming COM port. For example, the outgoing
COM port may be COM 5, and the incoming COM port may be COM
6. Do not be surprised if your COM ports are not set to COM 5 and
COM 6. The COM ports used can vary from computer to computer.
17. Press “tab” to get to the Finish button, and then press “Enter” to
activate it.
18. You will then be taken back to the Bluetooth devices setting dialog.
Press Ctrl-Tab twice to focus the COM ports tab control.
19. Press “tab” to get to the list of COM ports, and then press the Down
Arrow to move through the list of COM ports to make sure that they
match the COM ports that were mentioned when you completed the
Bluetooth device wizard. You should hear your first COM port, then
the direction, and then the name. After you press “down” Arrow
again, you should hear the next COM port, the direction, and name.
For example, when you press the “down arrow” key the first time, you
might hear, “COM 5 Outgoing Windows CE Blue Tooth Serial”.
When you press the “down arrow” key a second time, you might hear,
“COM 6 Incoming WindowsCE”.
20. Tab to the OK button, and press Enter.
You have now setup the Braille Sense OnHand and the computer.
However, you must properly setup Window-Eyes in order to use the
Braille Sense OnHand as a Bluetooth Braille display.
13.2.5.3 Setting up Window-Eyes