User's Manual

92
Then, you can move to the next setting by pressing “space-4.”
2) Set lines per page
This sets the number of lines per page to be embossed. It
includes the line that the page number is printed in. For
example, if it is set to 26, the content of the document will be
embossed with 25 lines and the page number is printed as the
26th line. If you want to change the value, type in the number of
lines that you want to emboss. Then, you can move to the next
setting by pressing “space-4.”
3) Print type
This sets whether the document will be embossed on a single
sided or a double sided (both sides). The default value is set to
double side embossing. If you want to emboss using single
sided embossing, press “space” until “Print type: single sided” is
displayed on the Braille display. Then, the setting will be
changed to single side embossing. If you want to go back to
double side printing again, press “space” again, and “print type:
double sided” will be displayed. After setting your preference,
move to the next setting by pressing “space-4.”
4) Page numbering type
This sets the numbering type for embossing a document. The
default type is set to “double sided.” It means that the page
number will be embossed on every page. The setting values
are “double sided,” “odd,” “even,” and “none.” These settings
are changed when you press “space.” Pressing “backspace”
will allow you to move in reverse order. When you have
selected your preference, you need to press “space-4” in order
to move to the next setting.
5) Set page numbering
This sets the position of the page number when embossing.
The selections are “upper-right” and “lower-right.” The default
setting is set to “lower-right.” Press “space” in order to change
the setting. Pressing “backspace” will allow you to move in
reverse order. After selecting your preference, you should
press “space-4” in order to move to the next setting.
6) Header
This is used to edit the header that will be embossed on the
head of every page. Move to “header” and type in the text to be
embossed as the header. In order to move to the next setting,
press “space-4.”