User's Manual

119
6.4.6 Location
In the “Location” field, you can type appointed location. If you press
“enter” after typing in the location, the record will be saved, leaving
the “memo” field empty, and the “alarm time” field set to its default
value (“time of appointment”). If you want to move to the next field,
press “tab (“space-4-5”),” instead of “enter.”
6.4.7 Memo
In the “Memo” field, you can enter detailed information about an
appointment. Here, you can type in more than one line. You can use
most of the editing commands that are used in the “word processor.”
Press “enter” to enter information on a new line. You can leave this
field blank if you want to. After you finish writing the information, you
can press “tab (“space-4-5”)” to move to the next field.
6.4.8 Alarm Time
The “alarm time” function allows you to set the time when you will be
notified about an appointment. The alarm is set relative to the
appointment time. For example, you may want the alarm to sound 30
minutes before your appointment, so that you are not late. The
default value for this field is set to “time of appointment.” This means
that the alarm will sound at the same time as you have set for your
appointment. You can set the time in the same way as when you set
the appointment time. The time can be set anywhere from one
minute to twenty-three hours and fifty-nine minutes. Refer to section
6.3 for more information about how to set the time. If you attempt to
set the time to 0, the Braille Sense Plus B32 will display the message,
“time of appointment.” If you do not want to set an alarm, press
“space-1” when “alarm time” is set to “time of appointment.” Then,
“alarm off” will be displayed, and the alarm for this appointment will
be turned off. After setting the “alarm time,” save this appointment by
pressing “enter,” or by pressing “tab (“space-4-5”)” to move to the
“confirm” button, and press “enter.” If you have set the “alarm time,” it
will go off at the specified time even if the Braille Sense Plus B32 is
turned off. If you want to stop the alarm, press “backspace-enter.”