User's Manual

178
If you want to register a specific host as a spam sender, do the
following:
1) Execute steps 1 through 5, as explained in section 7.5.4.
2) Press “space-4” when “type: subject 1/3” is displayed in order to
move to “type: host 3/3.”
3) Press “a (dot 1)” on “type: host 3/3,” or press “tab (space-4-5)” to
move to the “add” button, and then press “enter.”
4) Then, the “add dialog box” will be opened, and “host add: (host
address)” will be displayed. Here, “host address” is the host
address that was focused on when you executed this command.
5) Press “enter” on “host add: (host address).” Or, press “tab
(space-4-5) to move to the “confirm” button, and then press
“enter.”
6) Then, the Braille Sense Plus B32 will say “successfully added
spam data” and it will show “host: (registered host address) 1/1.”
If you add the host address as above, the e-mails from the registered
host will be downloaded from the e-mail server, but the Braille Sense
Plus B32 will delete them automatically. So those e-mails will not be
found in the inbox.
At step 5 above, you can add the additional host address by
modifying the host address that you have typed in. If you type in a
new host address at “host add: (host address),” the displayed host
address will be erased, and the new host address will be displayed.
But, if you press the “cursor routing key” at the position where you
want to modify the displayed address, that address will be modified
where you modify it.
If you want to add an additional host address, you can add it by
repeating step 3 above. Or, when “host: (registered host address)
1/1” is displayed, you can add it by pressing “a (dot 1)” or pressing
“tab (space-4-5)” to move to the “add” button, and then press “enter.”
You can check the registered host addresses by pressing “space-1”
or “space-4.”
When you register a subject, e-mail address, or host as spam e-mail,
you may make a mistake while you are typing in a subject, e-mail