User's Manual

310
Or, if the PC in which the Active Sync program is installed is
connected to Internet and the Braille Sense Plus B32 is connected to
that PC, then you can connect the Braille Sense Plus B32 to Internet.
The functions of this menu are explained in greater detail in the
following sections.
15.9.1 LAN Setup
If you are going to set up a LAN, you should first connect a LAN cable
to the Braille Sense Plus B32. In this setup, you can decide whether
you will use the automatic or manual setup to setup your IP
configuration. If you want to set it up automatically, press “enter” on
“setup IP: Automatic.” Then, it will be set up automatically. For the
automatic setup, your host server should provide DHCP service
(Dynamic Host Configuration Protocol).
If you want to set up your IP configuration manually, move to
“manual” by pressing “space-4” from the “setup IP: Automatic,” and
press “enter.” Then, you will find the following: “IP,” “subnet mask,”
“gateway,” and “primary DNS.” These settings require specific
information. Please contact your Internet service provider for the
right information. To type in the information, you should use
computer Braille, and after typing in the information, you can move to
the next item by pressing “space-4.” Finally after completing the
“primary DNS,” press “enter.” Then, you will see the message
“setting completed.” You will be returned to “setup internet” with your
information saved. You can then use e-mail, msn messenger or the
web browser.
15.9.2 Modem & Bluetooth DUN setup
If you are going to set up the Braille Sense Plus B32 to connect to the
Internet via a modem, you should first put in a CF type modem card
into the CF slot, and connect a phone line to the modem on the CF
card. Then, activate “setup Internet” in the “utility” menu. After you
have activated “setup Internet,” move to the modem by pressing
“space-1” or “space-4,” and then press “enter.”
If you wish to connect to Mobile network using Bluetooth DUN, you
can move to “setup internet” in the “utility” menu and select “Bluetooth
DUN” and enter on it. In this case, you don’t need to insert CF