User's Manual

311
modem card into the Braille Sense Plus B32 and its user interface is
same as setting up connection using the modem.
The modem setup contains the following: “connect list,” “default,”
“register,” “modify,” “delete,” and “close.” You can move between
these by pressing “tab (“space-4-5”)” or “shift-tab (“space-1-2”)”.
Within each item, you can move by pressing “space-4” or “space-1.”
The “connect list” has registered connection names. You can move
between these by pressing “space-4” or “space-1.”
The “default” is to set to the default connection name in the Internet
setup. If you want to choose a connection as the default, go to the
“connect list,” and move to “default” by pressing “tab (“space-4-5”)”.”
Then, press “enter.”
“Register” is a dialog box where you can set up the environment
regarding the connect group names. It has “connect name list,” a
“confirm” button, and a “cancel” button. You can move between
these by pressing “tab (“space-4-5”)” or “shift-tab (“space-1-2”)”. The
“connect name list” has “connect name,” “connect number,” “id,”
“password,” and “modem speed.” In “connect name,” you can type in
the host name to connect with, and in the “connect number,” you can
type in the number of the host. Here you can type in numbers and
commas (,) only. You can type in numbers using computer Braille. In
“ID” and “password,” use computer Braille to type the ID and
password that are required by the host server. In case of Bluetooth
DUN, you can make the connection to Mobile network without any
password according to Mobile server. In the modem speed, select
one from the list by pressing “backspace” or “space.” After
completing each item, you can move to the next item by pressing “tab
(“space-4-5”)”.” Finally, with “modem speed” completed, you can
press “enter” to save your registration. Before saving it, you can
cancel your choices by moving to “cancel” by pressing “tab (“space-4-
5”)”,” and press “enter” on it.
“Modify” is used to modify the connect group. You can do this by
moving to what you want to select in the “connect list,” and then press
“enter.” You can also press “tab (“space-4-5”)” to locate “modify.”
Otherwise, you can press “enter-m (1-3-4)” on the “connect name” in