User's Manual

314
points which is searched and the “add new…” to additional
registration.
“Access point” list will let you know the “access point name,”
“encryption,” and “sensitivity” of each item. (Ex: linksys, encryption:
WEP, sensitivity: good.) If there is more than one access point in the
list, you can move between them by pressing “space-1” or “space-4.”
Move to the “access point” that you want to connect to. And press
“enter.” Then you will show “the key is provided automatically” check
box. If you don’t use network key in Access Point, just press “enter.”
And if you are using network key in Access Point, press “space” and
press “tab (space-4-5).” And then edit box will be displayed. In edit
box, you have to input the encryption key and press “enter.” And if
your settings are correct, then you will hear “connected” after the
“sensitivity,” with connecting sound.
If you want to register new profile for hide Access Point, press the
“add new…” then the dialog box to register new profile will be opened
and this dialog box is same when opening “advance” common dialog
box.
The “advance” common dialog box is used to modify the registered
profile or add new profile or check the existed profile. If you press
“enter” on the “advance” button while wireless LAN turned off, “no
item” will be displayed. Pressing “enter” on the “advance” button,
while wireless LAN turned on. The “advance” dialog box has 5
controls. You can navigate among these controls by pressing “tab
(“space-4-5”)” or “shift-tab (“space-1-2”)”.
The “advance” common dialog box contains “profile list,” “add
common dialog” button, “remove” button, “properties common dialog”
button and “close” button controls.
1) “profile list”: Here you will see the profile lists that you have
registered. You can move through the list by pressing “space-4” or
“space-1.”
2) “add common dialog” button: You can register a profile here and
this dialog is same when entering on ‘add new’ in lists of Access
Point. “Add common dialog” has the 10 controls.