User's Manual

316
2-3-5)” or go to the “remove” button by pressing “tab (“space-4-5”)”,
and then press “enter” on “remove” button.
4) “properties common dialog” button: If you want to get information
about a selected profile item in the profile list, press “enter” on the
“properties common dialog” button after focusing on a profile item
by using “tab (“space-4-5”)”. You can reconfirm the registered
information in each item. You can modify an item here directly.
In order to exit from “advance” dialog box, you can press “space-
e(dots 1-5)” or “space-z(dots 1-3-5-6)”.
15.10 Network Status
Using this program, you can check if the Braille Sense Plus B32 is
currently connected to the Internet. This program provides you with
the information about the current connection type, the current IP of
the unit, subnet mask, gateway, and mac address. To run this
program, press “enter” on “network status,” or press “n (dots 1-3-4-5)”
in the “utility” menu. If you start the program, a list of information
about the connection type and address will be displayed. If you press
“tab (space-4-5),” the Braille Sense Plus B32 will display a “renew”
button. If you press “tab (space-4-5) again, “exit” will be displayed. If
you press “shift-tab (space-1-2),” the Braille Sense Plus B32 will
move between these elements in the opposite direction. The first
item in the information list (status) shows if the Braille Sense Plus
B32 is currently connected to the Internet (online/offline), and what
the current connection type is (LAN, Modem, ADSL, or Wireless LAN).
The next item is the “current IP address,” followed by “subnet mask,”
and then “gateway,” and finally “mac address.” You can move
between these items by pressing “space-4” or “space-1.” If the Braille
Sense Plus B32 is not currently connected to the Internet, the status
information shows that the Braille Sense Plus B32 is offline. If you
press “enter” on the “renew” button, it tries to connect to Internet
using the parameters specified in “setup Internet” once again, and
displays on/offline status. To end this program, press “space-z (dots
1-3-5-6)” at any time in the program. Or pressing “enter” on the “exit”
button will close the program too. You can also press “space-n (dots
1-3-4-5)” while you are in the “program” menu to open network status.