User's Manual

setting is set to “on,” which will use the power saving mode. The

“space” key switches between “on,” off, and “message.” If you don't

want to use the power saving mode, you can set the option to “off.” If

you set the option to “message,” you will hear a warning message

that says “power on” in 10, 20, or 30 minute increments (depending

on the setting that you will choose for power saving kick in) if you

have not pressed any keys on the Braille Sense Plus B32. The next

section explains how to change the power saving kick in to 10, 20, or

30 minutes. If you have changed the setting, press the “enter” key to

save the setting. You can also “tab (“space-4-5”)” or “shift-tab

(“space-1-2”)” to the “confirm” button, and press “enter.” If you do not

want to save the setting, “tab (“space-4-5”)” or “shift-tab (“space-1-

2”)” to the “cancel” button, and then press “enter.” You can also

cancel saving the setting by pressing “space–z (dots 1-3-5-6)” or

“space-e (dots 1-5).”

For your reference, this option is available only when the AC adaptor

is connected to the unit. In other word, although you set the option to

“on” if AC adaptor is connected to the unit, the unit will not go to the

sleep mode automatically when you meet the “power saving kick in”

time.

2.4.2.28 Power Saving Kick In

When you want to use the power saving mode, you can set the time

when the power saving mode will begin. The shortcut key is “k (dots

1-3)” with the default set at “after 10 minutes.” If you set this option to

the default, the Braille Sense Plus B32 will enter into power saving

mode when you have not used the Braille Sense Plus B32 for 10

minutes. The “space” key changes the option setting to 10 minutes,

20 minutes, or 30 minutes.

If you have changed the setting, press the “enter” key to save the

setting. You can also “tab (“space-4-5”)” or “shift-tab (“space-1-2”)” to

the “confirm” button, and press “enter.” If you do not want to save the

setting, “tab (“space-4-5”)” or “shift-tab (“space-1-2”)” to the “cancel”

button, and then press “enter.” You can also cancel saving the

setting by pressing “space–z (dots 1-3-5-6)” or “space-e (dots 1-5).”