User's Manual

3 of 8
l Reset switch
If you move your hand from the left edge to the right on the rear panel, you
can find reset button. If there is any mal-function of HANSONE, just press
this button using ball point pen or any other sharp edged tool. It will take
around 10 second to restart the HANSONE.
Some of data that was not stored to the flash memory by the user before
the Reset button is pressed may be lost.
l LAN port
LAN(Local Area Network) cable is connected to this port. This port is located
right side of reset switch.
In order to use LAN, you have to set IP address and so on. This will be
explained later in this manual.
l USB host port
This port is located at the right side of LAN port. If you want to use some
USB device, connect such USB device to this port. USB keyboard is one of
the sample of the usage of this port.
l USB client port
This port is located at the right side of USB host port. If you connect USB
cable of which the other end is connected to personal computer, you can
save your data in HANSONE to personal computer or retrieve the data
stored in personal computer.
l Parallel port
This port is located at the right side of USB client port on the rear panel. It
can be used to connect to an embosser (Braille printer) or a printer that has
parallel port.
l Serial Port
Serial port is located at the right side of parallel port. This port is used to
provide a connection to a personal computer or other device. The usage of
this port is almost the same as USB client port. But if you do not have USB
host port on you personal computer, you can save or retrieve your data to
and from your personal computer through this port.
l DC Adapter port
This is port is for power input and located at the right most on rear panel.
Plug the DC adaptor that is supplied with HANSONE in.