User's Manual

357
If this is the first time you have opened “Wake up alarm,” and you have
not yet set the time or date in the Voice Sense QWERTY, theVoice
Sense QWERTY will then say, “Set time:” After you set the time, the
Voice Sense QWERTY will display the “Wake up alarm” dialog box. The
Voice Sense QWERTY will then say, “Set time:” The “Wake up alarm”
dialog box contains the following: “Set time,” “Bell,” “Term,” “Alarm
duration,” “Repeat interval,” “Wake up call times” a “Confirm” button, and
a “Cancel” button. You can move among these by pressing “tab”and
“shift-tab”. If you want to check the wakeup call settings, open this dialog
box again. It will show you the current wakeup call settings. When the
alarm sounds, the LCD on the oice Sense QWERTY will also display the
message “Wake up call. Press “Ctrl” to stop the alarm.” If you want to
stop the alarm, press “Ctrl.” After you press “Ctrl,” the Voice Sense
QWERTY will remain on, even though the power switch is turned to
“Off.” In order to turn the Voice Sense QWERTY off, you must turn the
power switch to “On,” and then back to “Off” after you hit “Ctrl.” Then, the
Voice Sense QWERTY will be turned off, and the alarm will not sound
again until you set it again. If you do not plan on being able to turn the
unit off and on, you should turn on the “Power saving mode” in the
“Global options” (as explained in chapter 3) to avoid draining the battery.
17.5.1 Set Time
When you open the “Wake up alarm” dialog box, the Voice Sense
QWERTY will display the “Set time” field. The value is set to the current
time or the time specified previously. Here you can directly type in the
time, or set the time using the shortcut keys, as explained in section 7.3.
After you set the time, you should press “tab” to move to the next field.
While you are anywhere in the Voice Sense QWERTY, you can check
the time by pressing “Fn-t” to check the time.
17.5.2 Alarm Sound
You can select an alarm sound for the wake up alarm. If you press
“tab”on “Set time,” you will hear the alarm sound that is currently set.
Press “Up arrow key”or “Down arrow key”to change the alarm sound,