Instructions / Assembly

STEP 1: _________________________________________________________________________________________

Lay the shipping box flat to protect the Glider during Repeat the same process with the back Glider Base Support Stretcher

assembly. Begin to assemble the Glider Base by standing on the same side (B-R). Again, hand tighten with the Wrench

up the Glider Base right side (B-R) and align Glider Base provided. Fig. 2

Support Stretcher (I) with pre-dilled hole in Glider Base.

Insert Hex Head Bolt (F) into pre-drilled hole and hand

tighten with Hex Wrench provided. Fig. 1

FIG. 1 FIG. 2

STEP 1:____________________________________________________ _____________________________________

Stand Glider Base up on end and place Glider Base left side (B-L) Lay the assembled Glider Base back down and tighten all four Hex

on top of exposed Glider Base Support Stretchers and align the Head Bolts snug. For future note the two pre-drilled holes in the

pre-drilled holes. Insert the Hex Head Bolt into the pre-drilled hole Glider Base should be on the top shown in Fig. 4

and hand tighten with Wrench provided. Repeat the process for the

back Glider Support Stretcher. Fig. 3

Pre-drilled Holes

Fig. 3 Fig. 4