Instructions / Assembly

STEP 2:___________________________________________________________________ ______________________

Align the pre-drilled hole in the Glider Side (C-L) with the Glider Seat(J) Stand Glider up on its’ end and place Glider Side (C-R) on top of

and place the Hex Head Bolt (F) through the side into the seat. Using the Hex Glider Seat (J) and Glider Back (A). Align the pre-drilled holes

Wrench hand tighten the Hex Bolt. Repeat for the lower bolt in the back in the Glider Side with the Glider Seat and insert Hex Head Bolt (F).

of the seat. Fig. 9 Hand tighten and repeat for the rear pre-drilled hole in the Glider

side. Fig. 10

Fig. 9 Fig. 10

STEP 2:________________________________________________________________________________ ________

Align the pre-drilled holes in the upper Glider Side (C-R) to the Glider Place assembled Glider Base on floor so both sides are accessible.

Back (A) and insert Hex Head Bolt (F) and hand tighten with Wrench . Position the assembled Glider Upper over the Glider Base as shown

Repeat for lower pre-drilled hole on Glider Side (C-R). Fig. 11 in Fig. 12

Fig. 11 Fig. 12