Installation Guide

assembly instructions

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

*** The construction of this ﬁxture will be accomplished by ﬁrst assembling the

main body of the ﬁxture, attaching the mounting strap to the junction box,

making all necessary electrical connections, hanging the ﬁxture from the

ceiling, and then installing the glass lens.

start here

Make electrical connections from supply wire to ﬁxture lead wires. Refer to instruction

sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.

Then refer back to this sheet to continue installation of this ﬁxture.

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 1 - Mounting Detail

1. Prepare mounting strap (B) for mounting by installing screws (A) into mounting

plate (B) - see Drawing 1.

• Be sure the holes into which the screws are threaded match the spacing of holes (C)

in the canopy (1).

2. Attach mounting plate (B) to junction box (J), using screws (G) provided and slip

supply wires through large center hole.

1. Hang the ﬁxture by slipping canopy (D) over screws (B) and holding in position - see

Drawings 1.

2. Thread ball knobs (E) onto end of screws (B) and tighten to secure ﬁxture to ceiling.

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 8 0 0 . 4 4 6 . 5 5 3 9 / 4 4 0 .653.5500 hinkleylighting.com

PAGE 1
assembly instructions Drawing 1 - Mounting Detail J st a r t he re 1. Find a clear area in which you can work. B 2. Unpack fixture and glass from carton. 3. Carefully review instructions prior to assembly. A D C G E *** The construction of this fixture will be accomplished by first assembling the main body of the fixture, attaching the mounting strap to the junction box, making all necessary electrical connections, hanging the fixture from the ceiling, and then installing the glass lens. 1.
PAGE 2
grounding instructions SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS. Drawing 1 - Flush Mount supply wire A C Indoor Fixtures E 1 2 twist-on connectors D B fixture leads Drawing 2 - Chain Hung supply wire A C E twist-on connectors 1 B D E wiring instructions 2 fixture leads 1.