Installation Sheet

assembly instructions

Item No. 2222

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

*** The construction of this ﬁxture will be accomplished by ﬁrst hanging the

ﬁxture from the ceiling, making all necessary electrical connections, and then

installing the ﬁxture glass.

start here

2222

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 1 - Fixture Assembly

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

REVISION 2

WIRE

1. To begin assembly of your fixture first take the supply wire of the center cluster

assembly (A) and slip them through the center coupler / tube (B) located in top crown (C).

Slip wires through tube until they exit out the top loop (L) - see DRAWING 1.

2. Slip wire through coupler / tube (B) until the top of the center cluster can be threaded

into coupler (B) and tightened.

3. It is recommened that the above assembled parts be hung from the ceiling at this time.

Please refer to the hanging instructions sheet (IS-19) provided to continue installation of

this fixture. After installation, refer back to this sheet for glass installation instructions.

NOTE: glass can be installed prior to installation, but extra care is required during

installation to prevent breakage

1. To install glass first thread in bottom center stem (1), making sure beaded end is

threaded into bottom of center cluster (A) - see DRAWING 1.

2. Install bulbs at this time.

3. Next slip glass (2) over center cluster (A), making sure large hole in glass is facing

toward ceiling. Top of glass checks inside the edge of crown (C). Hold glass in postion

and slip cast bottom cover (3) onto center stem (1) and up to bottom of glass.

4. Now thread finial (4) onto end of center stem (1) and tighten to secure glass to fixture.

PAGE 1
2222 assembly instructions Item No. 2222 Drawing 1 - Fixture Assembly L WIRE s tart here C B WIRE 1. Find a clear area in which you can work. 2. Unpack fixture and glass from carton. 3. Carefully review instructions prior to assembly. *** The construction of this fixture will be accomplished by first hanging the fixture from the ceiling, making all necessary electrical connections, and then installing the fixture glass. A SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S.
PAGE 2
Drawing 1 - Hanging Assembly A 2 1. Shut off electrical current before starting. If the fixture you are replacing is turned on and off by a wall switch, simply turn the switch off. If not, remove the appropriate fuse (or open the circut breakers) until the fixture is dead. GS • DO NOT restore current - either by fuse, breaker or switch - until the new fixture is completely wired and in place. 3b 3a 4 1.
PAGE 3
grounding instructions SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS. Drawing 1 - Flush Mount wiring instructions supply wire A C Indoor Fixtures E 1.