Installation Sheet

assembly instructions
Item No. 3580
1. Find a clear area in which you can work.
2.
3. Carefully review instructions prior to assembly.
mounting strap to the junction box, making all necessary electrical connections, assem-
and then installing the glass.
star t here
3580
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 2 - Glass installation
5
6.1.12
Drawing 1 - Fixture Mounting
A
B
C
D
E
F
C
F
3
1
2
4
socket
ring
tool
6
5
T
A
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com
1. Remove main mounting plate (A) from fixture back plate (B) by removing the four
flat head screws (C) - see Drawing 1.
2. Slide the wires from the junction box, through the large center hole, making sure
curved slots (D) line up with the threaded holes (E) in the junction box.
3. Using two 8-32 screws (F) attach the main mounting plate (A) to the junction box,
making sure side of mounting plate (A) is square to ceiling.
Make electrical connections from supply wire to fixture lead wires. Refer to instuction sheet (I.S. 18) and
follow all instructions to make all necessary wiring connections. Then refer back to this sheet to continue
installation of this fixture.
1. Mount the fixture by sliding the back plate (B) over mounting plate (A) - see Drawing
1.
2. Attach the back plate (B) to the mounting plate (A) using the screws (C).
1. To install glass remove socket ring (2) and spacer (3) from socket (1).
2. Slip glass (4) over socket (1).
3. Slip spacer (3) over socket.
4. Thread socket ring (2) onto socket (1) and tighten until snug, using socket ring tool
provided.
5. To complete assembly slip decorative washer over threaded tube (T), then thread tail
into bottom of arm (A).