Instructions / Assembly

H I N K L E Y L I G H T I N G 12600 Berea Road Cleveland, OH 44111 800.446.5539 / 216.671.3300 www.hinkleylighting.com

installation instructions

Family: 120V Series Spot Light Item No. 55000 BZ

1. Find a clear area in which you can work.

2. Carefully review instructions prior to assembly.

3. Gather tools required: WIRE STRIPPERS, PHILIPS HEAD SCREWDRIVER,

SILICONE GREASE, THREAD SEALANT.

• Save these instructions for future reference.

start here

55000

WARNING: LUMINAIRE MUST BE INSTALLED AND GROUNDED IN ACCORDANCE

WITH THE NATIONAL ELECTRICAL CODE (NEC) AND LOCAL CODES. FOR PORTABLE

STAKE OR SUFACE MOUNT USING A CORD AND PLUG, THE LUMINAIRE MUST BE

PLUGGED INTO A RECEPTACLE PROTECTED BY A GROUND FAULT CIRCUIT

INTERRUPTER (GFI). FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY

AND/ OR DAMAGE TO THE LUMINAIRE.

ALWAYS USE UL RECOGNIZED WIRE CONNECTORS FOR CONNECTIONS.

IN GROUND LUMINAIRE IS ETL LISTED FOR ABOVE GRADE INSTALLATION ONLY.

SAFETY WARNING: LUMINAIRE CAN BECOME VERY HOT DEPENDING ON THE

LAMP WATTAGE USED. LENS AND HOUSING AROUND THE LAMP CAN BECOME

HOT ENOUGH TO BLISTER HANDS. PARTICULAR CARE SHOULD BE TAKEN NOT TO

LOCATE LUMINAIRES WHERE SMALL CHILDREN CAN REACH THEM IF HIGH

WATTAGE LAMPS ARE USED.

MAINTENANCE NOTE: TO ASSURE PROPER OPERATION AND EFFICIENCY AND TO

PREVENT LUMINAIRE OVERHEATING, LENS MUST BE KEPT CLEAN AND FREE OF

DIRT, LEAVES, TRASH, AND MINERAL DEPOSITS FROM WATER. A REGULAR

SCHEDULE MAINTENANCE PROGRAM IS RECOMMENDED.

1. Please refer to the mounting instructions located on the back of this sheet to

continue installation of this ﬁxture.

lamp installation replacement

1. To prevent electrical shock, disconnect from the electrical supply before servicing.

2. Loosen set screw from shroud assembly.

3. Remove shroud assembly to expose lamp.

4. Replace lamp with correct wattage and type marked on ﬁxture label.

CAUTION: DO NOT EXCEED MAXIMUM WATTAGE MARKED ON LUMINAIRE LABEL.

5. Re-install shroud assembly and tighten set screw.

6. After lamp is installed supply power to the luminaire and check for proper operation.

Info 55000 BZ: Lamp Type is Par 38 or R-40

Maximum Wattage is 175 watts per bulb.

3.4.08

PAGE 1
55000 installation instructions Family: 120V Series Spot Light Item No. 55000 B Z start here 1. Find a clear area in which you can work. 2. Carefully review instructions prior to assembly. 3. Gather tools required: WIRE STRIPPERS, PHILIPS HEAD SCREWDRIVER, SILICONE GREASE, THREAD SEALANT. • Save these instructions for future reference. WARNING: LUMINAIRE MUST BE INSTALLED AND GROUNDED IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE (NEC) AND LOCAL CODES.
PAGE 2
mounting instructions Family: 120V Series Spot Light Item No. 55000 B Z Drawing 1 - Fixture Mounting D 2 C 4 B 1 A (Diagram 2) (Diagram 1) 1. Make sure electrical supply is off at the circuit breaker before starting luminaire installation or servicing. 2. Thread luminaire onto junction box or other mounting device (not provided) until it is at desired direction using thread sealant. Tighten jam nut (A) provided to ensure the luminaire is locked to adjusted position - see Drawing 1/Diagram 2. 3.