Installation Sheet

assembly instructions

Item No. 1121

1. Find a clear area in which you can work.

3. Carefully review instructions prior to assembly.

star t here

1121

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

(I.S.

18) and follow all instructions to make all necessary wiring connections. Then refer back

Drawing 2 - Fixture Mounting

Drawing 1 - Fixture Assembly

1. Fixture is mounted using 3 - 1/4-20 set screws.

2. Make all necessary electrical connections following wiring instructions below.

1. (A) over top of pre-installed post (B)

making sure all wire connections are tucked inside the pole - see Drawing 2.

3. Thread the 3 set screws (C)

4. Tighten screws (C)

1. Remove ball knobs (2) located under the lip of the roof (1) and lift roof (1) off - see

Drawing 1

2. Fixture can now be lamped accordingly.

3. Place roof (1) back onto cage assembly (4).

4. Line up holes (5) in the roof (1) with the holes (6) in the cage assembly (4).5.

Thread ball knobs (2) back into holes to secure roof (1).

6. Dusk till Dawn photocell (7)

to this

REVISION 1

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

PAGE 1
121 assembly instructions Item No. 1121 s tar t he re Drawing 1 - Fixture Assembly 1. Find a clear area in which you can work. 7 1 2. 5 3. Carefully review instructions prior to assembly. 6 2 3 1. Remove ball knobs (2) located under the lip of the roof (1) and lift roof (1) off - see Drawing 1 2. Fixture can now be lamped accordingly. 3. Place roof (1) back onto cage assembly (4). 4 4. Line up holes (5) in the roof (1) with the holes (6) in the cage assembly (4).5.
PAGE 2
grounding instructions SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS. Drawing 1 - Flush Mount wiring instructions supply wire A C Indoor Fixtures E 1.