Instructions / Assembly
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Av on Lake, OH 44012 800 .446 .5539 / 440.653.5500 hinkley
lighting.com
Installation Instruction
start here
Item No:
1536LL
SAVE THESE INSTRUCTIO
Note: This Luminaire is designed for use with Hinkley approved 12 volt
landscape systems. Connection to other systems may cause premature
failure or non-intended operation.
1.
Find a clear area in which you can work.
2.
3.
LUMINAIRE MOUNTING: (for typical ground stake mounting)
1. To prevent electrical shock, disconnect transformer from electrical supply
before installation or service.
2. Run wire from Luminaire through mounting hole in top of ground stake.
3. Attach Luminaire to ground stake by threading to the mounting hole in stake
until it fits snuggly against the bottom of stem.
Place stake in desired position and insert into ground until the flange of stake
is flush with ground.
5. Strip the two wire leads from the Luminaire and connect to the main supply
wire using the provided silicone filled wirenuts.
Protected by routing in close proximity to the luminaire or fitting, or next to a
building structure such as a house or deck.
The main secondary wire is intended for shallow burial – less than 6 inches
(15.2cm)
- in order to connect to the main low voltage cable.
Have the length cut off so that it is connected to a connector within 6 inches
(15.2cm) from a building structure, a luminaire or fitting.
1.
Encontrar un área clara en la que se puede trabajar.
2.
3.
empezar aquí
Número
tierra)
superior de la estaca de tierra.
brida de estaca quede al ras con el suelo.
El principal cable de baja tensión de la luminaria es:
1. Protegido por la ruta cerca de la luminaria o el accesorio, o al lado
de una estructura de edificio como una casa o una cubierta.
2. El cable secundario principal está diseñado para enterramiento
superficial: menos de 6 pulgadas (15,2 cm)
- Para conectarse al cable principal de baja tensión.
3.
Corte la longitud para que se conecte a un conector dentro de 6 pulgadas
(15,2 cm) de una estructura de edificio, una luminaria o un accesorio.
Instrucciones de Instalacion
:
Le câble principal basse tension du luminaire doit être
commencer ici
Número del
artículo:
del actculo:
HH
II
NN
KK
LL
EE
YY
ACCENT SPOT LIGHT
1535MZ
1536BZ
GUARD
LAMP
ENCLOSURE
ENCLOSURE
SPRING
1536LL
1536LL