Installation Sheet

assembly instructions
Item no. 1671
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first making all
necessary electrical connections and then mounting fixture to pre-installed post.
start here
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to complete installation of this fixture.
Drawing 2 - Fixture Mounting
1. After wiring connections are complete, slip post fitter (A) over top of pre-installed
post (B) making sure all wire connections are tucked inside the pole - see Drawing 2.
2. When fixture is slipped over pole make sure no wires are being pinched between
the top edge of the pole and the inside of the post fitter.
3. Thread the 3 set screws (C) into pre-tapped holes in post fitter.
4. Tighten screws (C) to secure fixture to post.
3.19.09
HIN K L E Y LIGH T I N G 330 00 P in O ak P ar kw ay Avon L ak e, O H 44 01 2 800.446.5539 / 440.653.5500 hinkleylig ht in g. co m
1
3
2
Drawing 1 - Fixture Mounting
1. To assembly fixture open cage door (1) by lifting latch on side of door - see
Drawing 1.
2. Slip candle sleeves (2) over socket (3).
3. Fixture can now be lamped accordingly.
REVISION 1