Installation Sheet

assembly instructions

Family: Hadley Item No. 3302

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

1. Prepare gem strap (A) for mounting by threading two screws (B)

provided into back of gull wing bracket of gem strap (A) - see Drawing 1.

• Be sure the holes into which the screws are threaded match the spacing of holes (D)

in the ceiling pan (1) - see Drawings 1 and 2.

2. Mount gem strap (A) to junction box (J), using the two 1” screws not provided (C)

Make electrical connections from supply wire to ﬁxture lead wires. Refer to instruction

sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.

Then refer back to this sheet to continue installation of this ﬁxture.

1. Hang the ﬁxture by slipping the holes (D) in the ceiling pan (1) over the screws (B)

in the mounting strap (A) - see Drawing 2.

2. Thread on ball knobs (F) to secure ﬁxture to the ceiling.

1. Prior to installing glass, ﬁxture should be lamped.

2. To install glass (2), lay glass into ring (3).

3. Slip the 3 holes (H) of ring over the thr

eaded studs (G) of the uprights (UP) and hold

in position.

4. Thread decorative knobs (4) onto end of studs (G) and tighten to secure glass.

*** The construction of this ﬁxture will be accomplished by ﬁrst mounting the

mounting strap to the junction box, making all necessary electrical connections,

hanging the ﬁxture from the ceiling, and then installing the glass.

start here

3302

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 2 - Fixture Mounting

Drawing 3 - Glass Installation

Drawing 1 - Strap Detail

(side view)

gull wing

bracket

01.01.13

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 h i n k l e y l i g h t i n g . c o m

T24 JA8-2016

PAGE 1
3302 assembly instructions Family: Hadley Item No. 3302 T24 JA8-2016 s tart he re Drawing 1 - Strap Detail B B 1. Find a clear area in which you can work. gull wing bracket 2. Unpack fixture and glass from carton. 3. Carefully review instructions prior to assembly.
PAGE 2
grounding instructions SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS. Drawing 1 - Flush Mount supply wire A C Indoor Fixtures E 1 2 twist-on connectors D B fixture leads Drawing 2 - Chain Hung supply wire A C E twist-on connectors 1 B D E wiring instructions 2 fixture leads 1.