Installation Guide

HINKLEY LIGHTING 12600 Berea Road Cleveland, OH 44111 800.446.5539 / 216.671.3300 www.hinkleylighting.com

assembly instructions

Family: Pinnacle Item No. 5250 AN/CM

1. Find a clear area in which you can work.

2. Unpack ﬁxture and glass from carton.

3. Carefully review instructions prior to assembly.

1. Prepare gem strap (A) for mounting by threading two screws (B) provided into

back of gull wing bracket of gem strap (A) - see Drawing 1.

• Be sure the holes into which the screws are threaded match the spacing of holes (D)

in the back plate (E) - see Drawings 1 and 2.

3. Mount gem strap (A) to junction box (J), using the two 1” screws (C) provided.

Make electrical connections from supply wire to ﬁxture lead wires. Refer to instruction

sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.

1. Mount the ﬁxture by slipping the holes (D) in the backplate (E) over the screws (B)

in mounting strap (A) - see Drawing 2.

2. Thread on ball knobs (F) to secure ﬁxture to the wall.

1. To install gass, remove socket ring (1) from the socket (2) - see Drawing 3.

2. Place glass (3) over socket (2).

3. Thread socket ring (1) back onto socket (2) and hand tighten.

Note: Using a tool or overtightening may cause glass damage.

4. Fixture can now be lamped accordingly.

*** The construction of this ﬁxture will be accomplished by ﬁrst mounting the

mounting strap to the junction box, making all necessary electrical connections,

mounting the ﬁxture to the wall, and then attaching the shade to the ﬁxture.

Note: Maximum wattage for 5250 ﬁxture is 100 watts per bulb.

start here

5250

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 3 - Glass Installation

Drawing 1 - Strap Detail

Drawing 2 - Fixture Mounting

(side view)

gull wing

bracket

backplate

12.30.08