Installation Sheet

FRIS19-06
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply o during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1 Shut o electrical current before starting. If the fixture you are replacing is
turned on and o by a wall switch, simply turn the switch o. If not, remove the
appropriate fuse (or open the circut breakers) until the fixture is dead.
• DO NOT restore current - either by fuse, breaker or switch - until the new
fixture is completely wired and in place.
STEP 2
1 Slip mounting screw (6) through hole (c) from the back of retaining plate (1).
Attach mounting screws (6) to retaining plate (1) using lockwasher (7) and hex
nut (8) .
2 Attach retaining plate (1) to junction box (2) with the two screws (3) not provided.
Note: It is recommended that additional support be added at points (a). No
hardware is provided and it is up the customer to determine proper mounting
hardware to be used for their particular application.
3 Slip holes (b) in canopy (4) oner threaded stems (6) and hold in position,
making sure not to pinch wires.
4 Thread decorative barrel knobs (5) onto end of threaded stems (c) and tighten to
secure fixture to ceiling.
[DRAWING 1]
6.15.10
2
1
a
4
5
b
3
8
6
7
6
c