Installation Sheet

INSTALLING THE LIGHT KIT AND GLASS SHADE

NOTE: Be sure the power is oﬀ before installing.

Remove one of the three screws on the mounting hub

located on the fan motor. Loosen the other 2 screws. (Do not

remove) (Fig. 1)

Pass the light wires through the center hole of the mounting

plate.

Place the key holes on the mounting plate over the 2 screws

previously loosened, turn the mounting plate until it locks in

place at the narrow section of the key holes. Secure by

tightening the 2 screws previously loosened and the one

previously removed.

Remove one of the three screws on the mounting plate

located on the fan motor. Loosen the other 2 screws. (Do not

remove) (Fig. 2)

Fig. 1

Light Wires

Mounting plate

Mounting Hub

(bottom of motor)

Screws

Fig. 2

While holding the LED light kit under your fan, make the

polarized plug connections: (Fig. 2)

- Red to white

- Black to black

Tuck connections neatly into mounting plate. Place the key

holes on the light kit over the 2 screws previously loosened,

turn the light kit until it locks in place at the narrow section of

the key holes. Secure by tightening the 2 screws previously

loosened and the one previously removed.

Raise the glass shade against the LED light kit and turn

clockwise until snug, DO NOT OVERTIGHTEN.

Restore power and your light kit is ready for operation.

hinkley.com

Glass shade

Screws

Mounting plate

Wire connectors