Instructions / Assembly

BLADE ATTACHMENT
1. Place fiber washer on screw. Insert this assembly through the blade and start the screw into the blade arm. Repeat
this procedure without tightening the screw until all 3 screws have been started into the blade arm (Fig. 1).
NOTE:
NOTE:
Fans that have painted finishes are packed with gaskets that can be used between the blade arm and blade to
help prevent a clicking noise that may develop if blade screws loosen over time.
2. Tighten each screw starting with center screw.
3. Fasten blade assembly to motor with provided screws and lock lockwashers. Repeat procedure for remaining
blades (Fig. 2). Make sure screws are TIGHT!
TIGHT!
Loose motor screws can contribute to unnecessary hum during
operation.
NOTE:
NOTE:
Cordless power screwdrivers are NOT
NOT
recommended, as they tend to strip the heads of the screws and usually
will not fully compress the lock washers on the motor screws. Use a large flat blade screwdriver for final tightening to
fully compress the washers. This will help ensure proper alignment of the blades and noise-free, wobble-free running.
10
Fig. 1
Fig. 2
Screw
Fiber Washer
Blade Arm
Blade
Install gasket between
blade arm and blade
(optional)
Screws
Blades Assembly