Instructions / Assembly

INSTALLING THE FAN - DOWNROD STYLE
1. Carefully support fan body (motor) in its styrofoam packing with the mounting collar (where the wires come out)
facing upward.
2. Remove ball from downrod by loosening set screw in the side of the ball. Slide ball down and remove ball pin; remove
ball.
3. Feed the wires from top of fan through the coupling cover end of downrod and set end of downrod into mounting
collar so the hole in the downrod lines up with the hole in the side of the mounting collar.
4. Insert downrod pin through holes in mounting collar and downrod; slip cotter pin through small hole in end of
downrod pin to hold downrod in place.
5. Tighten security screws against downrod using a large flat blade screwdriver to ensure a tight fit against downrod.
Tighten nuts against mounting collar.
NOTE:
NOTE:
Fan has 6 feet of hook-up wire in case
you are using a long extension downrod. Wires
can be cut so only 8 inches or so extend beyond
the top of the downrod to make the electrical
connections easier and safer.
6. Feed wires through canopy and slide canopy
over downrod. It will be attached to ceiling
later.
7. Feed wires through ball and slide ball over
downrod, past hole in the top end of the
downrod. Insert ball pin (removed in step 2),
slide ball up, and tighten set screw to secure
ball in place.
7
INSTALLATION OPTION #2: DOWNROD STYLE MOUNTING
Ground Wire
(Optional extension shown)
Trim Ring
Hook-up (3) Wires
Ball
Canopy
Downrod
Mounting Collar
Downrod Pin
Collar Cover
Security Screws
Cotter Pin
Top of
Fan Body