Installation & Assembly

assembly instructions

Item No. 1801 OZ

1. Find a clear area in which you can work.

3. Carefully review instructions prior to assembly.

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)

AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING

INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED

ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

start here

Drawing 1 - Fixture Assembly

Drawing 2 - Fixture Mounting

1801

sheet 18 (I.S. 18) and follow instructions to make all necessary wiring connections.

1. (A) over top of pre-installed

post (B) making sure all wire connections are tucked inside the pole - see Drawing 1 .

3. Thread the 3 set screws (C)

4. Tighten screw (C)

11.12.09

1. Remove screws (2) from under roof (1). Make sure cage assembly (3) is supported

Drawing 1.

2. Remove screws (4) that hold the glass clips (5) in place.

3. Glass (6) can now be lifted out of the cage assembly (3) .

To replace glass, follow steps 1-3 in reverse order.

tighten.

L IGH TIN G

HINKLEYHINKLEY

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

PAGE 1
L I G H T I N assembly instructions G 1801 HINKLEY Item No. 1801 OZ Drawing 1 - Fixture Assembly 7 s tart here 8 1. Find a clear area in which you can work. 1 2. 3. Carefully review instructions prior to assembly. 4 6 5 2 1. Remove screws (2) from under roof (1). Make sure cage assembly (3) is supported Drawing 1. 3 2. Remove screws (4) that hold the glass clips (5) in place. 3. Glass (6) can now be lifted out of the cage assembly (3) . 4.
PAGE 2
L I G H T I N I.S. 18 wiring grounding instructions G I.S. 18 HINKLEY SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS. Drawing 1 - Flush Mount wiring instructions supply wire A C Indoor Fixtures 1.