Installation & Assembly

Installation Instructions
Well Light: Low Voltage | Item No. 15702, 15705, 15708
With included LED engine or MR16LED
 Start Here
HINKLEY LIGHTING 33000 Pin Oak Parkway Avon Lake, OH 44012 (p)800.442.5539 / (f) 440.653.5555 www.hinkleylighting.com
SAFETY WARNING: TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A
QUALIFIED ELECTRICIAN OR LOCAL AUTHORITY FOR
CODE REQUIREMENTS.
Top
Glass Lens
Pivot Sleeve
Housing
Optional
Concrete
Burial Sleeve
Top Cover Options
15705
15702
15708
Luminaire Mounting (for typical in-ground mounting)
1. To prevent electrical shock, disconnect transformer from electrical
supply before installation or service.
2. Luminaire may be directly buried in the ground. For concrete applica-
tions, a removable burial sleeve and cap is included. Use cap when
pouring concrete and discard after installation of the luminaire.
3. In earth burial applications, the best way to extend xture life is to use
sand, gravel or any other material to facilitate drainage.
4. Strip the two wire leads from the luminaire. Connect the main supply
wires using the provided silicone lled wire nuts or quick connectors
that are approved for outdoor use.
Note: Wire is to be protected by routing in close proximity to the luminaire,
tting or next to a building structure such as a house or deck. Wiring should
be buried a maximum of 6 inches (15.2 cm) in order to connect to main
supply wire. The main supply wire must have its length cut o within 6 inches
(15.2 cm) from a building, structure, luminaire or tting.
LED Engine or MR16 LED Installation
Three optics are included with the well light. A white spot lens, grey
medium spread lens and a black ood lens. Place desired optic in the
LED engine and twist to secure.
1. To prevent electrical shock, turn o transformer from electrical supply
before installation or service.
2. Using a Philips head screw driver, remove top screws and xture top.
Set these aside for use in reassembly.
3. Remove silicone gasket and glass lens.
4. Bring bi-pin socket out of housing, and insert the LED engine or MR16
LED assembly, in the socket. Making sure they are pushed into the
socket all the way.
5. Put the LED engine or MR16 LED assembly, with attached socket, into
the pivot sleeve. The engine sits in the sleeve freely.
6. Adjust the light direction by turning the pivot sleeve. The sleeve itself
can be turned 360º and the pivot cup inside has a 20º adjustment. The
screws on the pivot sleeve can be tightened to secure the cup in the
correct angle.
7. Return the silicone gasket and glass lens. Making sure the gasket is
seated correctly. Make sure to align the cut-outs in the gasket to the
screw holes
8. Screw the xture top back on.
IMPORTANT OPERATION NOTE: This luminaire is designed to be
operated with Hinkley approved 12 volt AC systems.
NOTE: Luminaire can be placed in an area where a car may drive over the
luminaire.
Earth BurialConcrete Burial
Route to Transformer
Optional
Concrete
Cap
Silicone
Gasket
Black
Flood Spread Lens
Grey
Medium Spread Lens
White
Spot Lens
360º rotation
20º rotation
LED Engine
or
MR16 LED
LED Engine Optic Options