User Guide

17
3.1 Basic Procedure
索引
4
3
2
1
7
6
5
10
9
8
Cable Testing Procedures
Cable Testing
Procedures
Chapter 3
3.1 Basic Procedure
To avoid equipment damage, do not attempt
to test a cable connected to an operating net-
work. The RJ-45 cable test jacks on the HiT-
ester and terminators are intended for testing
only stand-alone cables.
The characteristics of twisted-pair cables can vary
depending on installation conditions. Avoid unnec-
essary bending of cables to be tested. When nec-
essary to bend a cable, the radius of curvature
should be at least four times the outer diameter of
the cable.
Wiremap
1
P
ower
O
N
2
Press the key to start testing
TES
T
3
Test results are displayed
<Display Example>
Cables being checked
Terminato
r
Cable Length
ID Number