User Manual

Revision 01

 Connecting the instrument via LAN

You’ll need a LAN cross cable.

Launching and connecting to the application

1. Double-click the application’s shortcut on the desktop. The measurement screen will be

displayed.

2. Select the Function and Interface then click [Connect].

3. If you get an error message like the one on the right,

please make sure that you are using the correct IP address and port.

Also, the port may be used by other applications.

Application interface

This application will force the following settings upon connection. When the application is closed, the

following settings will be restored to the original settings at the time of connection.

※If it does not exit successfully or cannot communicate on exit, the settings remain as follows.

・Response of measured value and status. :MEASure:VALid 255

・Command monitor OFF.

・Automatic data output setting OFF.