User Manual

2.2 Settings for Waveform Calculation

When calculation results overflow (OVER)

• The displayed A/B cursor values (and those printed when the printer recording

type is set to [Numeric]) are incorrect.

• When [Scale] is set to [Auto], waveforms appear at the top or bottom edge of

the screen. This makes calculation result overflow obvious.

Waveform calculations with Timebase 2 (measurements using sampling

rate 2)

• Calculation equations Z1 to Z8 apply only to Timebase 1, and Z9 to Z16 apply

only to Timebase 2.

• Channel data set to use Sampling Rate 1 can only be used in equations Z1 to

Z8, and channel data set to use Sampling Rate 2 can only be used in equa-

tions Z9 to Z16.

• Inclusion of the results of one calculation (Zn) in another is also limited to only

those calculations which apply to the same timebase.

(Example: equation Z8 can include only the results of Z1 to Z7, and Z16 can

include only the results of Z9 to Z15.)

Defining Constants

To open the screen: Press the SET key → Select with the SUB MENU keys →Wave Calc Settings scree

Operating Key Procedure

SHEET/PAGE

Select the [Const] page.

CURSOR

Move the cursor to the Constant No. to be de-

fined.

F1 to F8

Select an entry method, and enter the constant.

Setting range: -9.9999E+29 to +9.9999E+29

See "3.3.3 Entering Text and Numbers" in the

Instruction Manual

Constant No.

Defined constants are shown in the constant display of the calculation equation setting dialog.