User Manual

2.2 Settings for Waveform Calculation
30
Calculation Waveform Display Settings
To open the screen: Press the SET key → Select with the SUB MENU keys →Wave Calc Settings scree
n
Operating Key Procedure
1
SHEET/PAGE
Select the [Scale] page.
2
Enable waveform display, and display color
CURSOR
Move the cursor to the [Color] column.
F1 to F8
Select whether to display the waveform, and its
color (when On)
3
Select a method to set scaling
CURSOR
Move the cursor to the [Scale] column for the Cal-
culation No. to be set.
F1 to F8
Set the display range for the calculation wave-
form.
4
Set the upper and lower limits of the display range (when
[Manual] is selected)
CURSOR
Select [Lower] and [Upper].
F1 to F8
Select an entry method and enter the limit values.
Entry range: -9.9999E+29 to +9.9999E+29
5
Specify the physical units
CURSOR
Move the cursor to the [Units] column.
F1 to F8
Select an entry method and enter the physical
units.
6
Enter a comment (as occasion demands)
CURSOR
Move the cursor to the [Comment] column.
F1 to F8
Enter your comment.
Waveform
Color
Upper and Lower Limits
Displayed
Measurement Units
Display Range
Setting Method
Calculation No.
Settings can also be made
in a dialog. (
⇒ p. 31)
To copy settings
between Calculation Nos.:
Select F2 [Copy].
Comments
23
56
4
1
Off The waveform is hidden.
2
On The waveform is displayed.
(default setting)
Auto Automatically sets the display range of
the vertical axis. (After calculation, the
upper and lower limits are obtained from
the results, and set automatically.)
Manual Upper and lower limits of the vertical axis
display range are entered manually.
Depending on calculation results, auto
-
matic scaling settings may be unsatisfac
-
tory, in which case the limits must be
entered manually.
See "3.3.3 Entering Text and Num-
bers" in the Instruction Manual