User Manual

3.3 Operation Workflow

Measurement Configuration

Settings

Make settings on the Status Settings screen.

Press the SET key to open the Settings screen

Press the SUB MENU keys to select the

Select the input data

Select whether to analyze newly acquired data, or

existing data.

Select the frequency range and number of

points for FFT analysis

Select the desired window function

Set the window function to be applied to the input

signal.

Select the peak value display

Select whether to display local or global maximum

result values (maximal/ maximum).

Set averaging

If averaging is desired, select the method and

count for averaging.

Set highlighting (attenuation correction rate,

for phase spectrum analysis only)

Select whether a spectrum is to be displayed with

highlighting. If highlighting, sets the attenuation

correction ratio to the maximum value of the power

spectrum (or cross-power spectrum).

Select the analysis type

Select the analysis type, x axis, y axis, waveform

color and channels to be analyzed (up to eight).

Set scaling

Set the display scale of the vertical (y) axis.

See "3.4 Setting FFT Analysis Conditions" (⇒ p. 51)