User Manual

3.6 Setting the Screen Layout of the Waveform Screen
72
Measurement data can be split and displayed on up to 16 sheets on the Wave-
form screen.
3.6 Setting the Screen Layout of the Waveform
Screen
1
4
3
2
Operating Key Procedure
1
Sheet Assignment.
CURSOR
F1 to F8
Move the cursor to the [Sheet 1] item.
Select the number of the Sheet to set.
CURSOR
F1 to F8
Move the cursor to the [On] or [Off] item.
Select whether to display the selected sheet on
the Waveform screen.
2
Enter a Sheet Name (if you want to change it).
CURSOR
F1 to F8
Move the cursor to the [Sheet Name] item.
Enter a name. (up to 8 characters)
(When you enter a sheet name other than the de-
fault, it is displayed to the right of the waveform.)
3
Select the Display Type.
CURSOR
Move the cursor to the [Display Type] item.
F1 to F8
Select the type of data to be displayed.
The display type depends on the input data se-
lected for analysis.
* Input data source [Reference]: selectable only
when [From Mem] is selected.
4
Select split-screen display (as occasion demands).
The number of possible screen partitions depends on the selected
display type.
See "Display Types and Split-Screen Settings" (⇒ p. 74)
Off The selected sheet is not displayed.
On The selected sheet is displayed.
FFT
Displays a plot of FFT analysis re
-
sults.
Nyquist
(When the analysis mode is Linea
r
Spectrum, Transfer Function o
r
Cross-Power Spectrum)
The real-number part is displayed o
n
the x axis, and the imaginary part o
n
the y axis.
FFT+Nyquist
Analysis results and the Nyquist plo
t
are displayed at the same time.
Wave+FFT *
A memory waveform and FFT analy
-
sis results are displayed.
Wave+Nyquist *
The Memory waveform and Nyquis
t
plot are displayed at the same time
.
Assigning the Results of FFT Analysis to a Sheet
To open the screen: Press the SET key → Select with the SUB MENU keys →Sheet Settings screen
See Screen Layout (
⇒ p. 42)
To use an existing memory waveform
for analysis
Select [From Mem] as the input data
source [Reference].
See "3.4.2 Selecting the Data Source
for Analysis" (
⇒ p. 52)
To specify the analysis starting point
Specify the starting point on the memory
waveform.
See "3.9.3 Analyzing after Specifying
an Analysis Starting Point" (
⇒ p.
80)