User Manual

1.1 Numerical Value Calculation Workflow

Before Setting When specifying a waveform range for calculation: [A-B]

Before executing a calculation, specify the calculation range using the A/B cur-

sors (Vertical or Trace cursors) on the Waveform screen. Set the calculation

range on the Num Calc Settings screen to [A-B].

• Horizontal cursors cannot be used to specify the range.

• When one cursor is used, the calculation range is from the cursor to the end of

the data.

See "8.7 Specifying a Waveform Range" in the Instruction Manual

"1.2 Settings for Numerical Value Calculation" (

⇒ p. 6)

To change calculation settings and recalculate

You can make changes to calculation settings and resume calculations from the

Waveform screen.

See "To recalculate after changing calculation type settings" (⇒ p. 9)

The following two calculation methods are available:

• Calculate while measuring

Requires making numerical calculation settings beforehand.

• Apply calculations to existing data

Calculations can be applied to data after waveforms are acquired, or after

data has been saved to storage media.

1.1 Numerical Value Calculation Workflow