User Manual

2.2 Connecting the Cables
23
Connection Procedure: Current measurement (with Model 9319 Conversion Cable)
(for Model 3273 or 3273-50Clamp-On Probe)
1 Align the slots in the clamp-on probe plug
with the pins on the input module’s BNC
jack, press and twist.
2 Align the groove in the conversion cable
plug with the sensor receptacle on the
input module, then insert and twist the plug
until it locks.
3 Align the groove in the probe’s power
cable plug with the conversion cable
receptacle, and mate the connectors.
4 Clamp the sensor around the measure-
ment object.
To remove the conversion cable
Push and twist the plug to unlock it, then
pull it out.
Example: When using the Model 3273 Clamp-On Probe
Required item:
Models 9319 Conversion Cable and 3273 Clamp-On
Probe
BNC jack
Sensor Receptacle
Connect to the measurement object
Connecting the clamp and the
Model 9319 Conversion Cable
Conversion Cable
Receptacle
Measurement Signal Plug
Alignment Notch
1
2
4
3273 Clamp-On Probe
1
2
3
Conversion Cable Plug
Power Cable Plug