User Manual

2.2 Connecting the Cables
25
1 Connect the BNC plug from the sensor to
a BNC jack on the input module.
Align the slots in the BNC plug with the guide
pins on the jack on the input module, then push
and twist the plug clockwise until it locks.
2 Connect the sensor to the measurement
object.
Disconnecting BNC connectors
Push the BNC plug, twist it counterclock-
wise, and pull it out.
Required item:
Preamplified acceleration sensor
BNC jack
Connection Procedure: Using a preamplified acceleration sensor
When using a sensor/preamp that has no BNC plug
Use an adapter or conversion cable to connect to the BNC jack.
Lock
Input module
connector guide pins
BNC plug slots
Connect to the measurement object
Connecting a preamplified
acceleration sensor
1
2
1 Connect the miniature plug from the
charge-output acceleration sensor to the
receptacle on the input module, and twist
the plug clockwise until tight.
2 Connect the sensor to the measurement
object.
To disconnect the miniature connector,
twist the plug counterclockwise and pull it
out.
Required item:
Charge-output acceleration sensor
Miniature Connector
Connection Procedure: Using a charge-output acceleration sensor
With a charge-output sensor that does not have a (#10-32) miniature connector
Use an adapter or conversion cable to connect to the miniature connector.
Connect to the measurement object
Connecting the charge-output
acceleration sensor
1
2