User Manual

3.2 Model 8937 Voltage and Temperature Unit Settings
46
3.2.2 Temperature Measurement
Setting Procedure
Use the CURSOR keys to move among items. Select a setting with the F1 to F8 keys.
Step
Setting Item
Description
1
Select the module No.
[Unit ]
Select the number of the input module to set up.
("Channel Configuration" (
⇒ p. 15))
2
Select the channel No.
[Ch ]
Select the channel number on the input module.
3
Confirm the module
[Module]
Confirm that the display is set for [Volt/Temp].
4
Select the measurement mode
[Mode]
Select [Temp].
5
Select thermocouple
[Sensor]
Select the type of thermocouple (⇒ p. 68).
[ K, J, E, T, N, R, S or B ]
6
Select the measurement range
[Range]
Select the appropriate measurement range. The setting val-
ue is the units per division on the vertical axis.
The RANGE/POSN knob selects the range (
⇒ p. 64).
[ 10, 20, 50 or 100°C/div ]
7
Select the low-pass filter
[LPF]
To suppress high-frequency components, select a low-pass
filter within the input module (
⇒ p. 66).
[ Off, 5Hz or 500Hz ]
8
Set the reference junction compensa-
tion
[RJC]
Select whether reference junction compensation should be
provided internally (
⇒ p. 68).
[ Internal or External ]
9
Set drift correction
[Drift]
Set whether to cancel variations in the reference voltage. Set
this On to improve the temperature characteristic (
⇒ p. 69).
[ Off or On ]
Set up scaling
Set as occasion demands.
See
"5.4 Converting Input Values (Scaling Function)" in the
Instruction Manual
([One Ch] Page of Channel Setting Screen)
8
12 3
5
6
4
9
The [Voltage] measurement mode is
selected upon system reset.
7