User Manual

4.1 Operation Overview

After turning power on, set the measurement criteria before measuring.

This chapter describes the settings related to logic inputs.

Refer to "7.3 Displaying Logic Waveforms" in the Instruction Manual for setting

details.

Measurement status and trigger settings are the same as for analog inputs.

Refer to the related chapters in the Instruction Manual.

Logic Input

Settings Chapter 4

4.1 Operation Overview

(Select the Function)

To record simultaneously with an analog signal, select a function that suits

the analog input.

When recording only logic signals, the function can be set freely.

Select the measurement status and

channels

(For Memory Function)

[Use Ch] page on Status Settings screen

Enable (set to On) the logic channels to be used.

See "4.2.1 Selecting Channels to Use" in the Instruction Manual

Set up input channels

[Logic] page on Channel Settings screen

Select whether to enable (On) or disable (Off) the input waveform for each

logic channel probe.

(Default setting: All Off)

Select waveform colors as desired.

See "7.3 Displaying Logic Waveforms" in the Instruction Manual

Set trigger criteria

[Logic] page on Trigger Settings screen

To apply a trigger event for measurements, set the logic trigger for each

channel.

See "6.8 Triggering by Logic Signals (Logic Trigger)" in "Chapter 6 Trigger

Settings" in the Instruction Manual

Waveform display settings

[Logic] page on Sheet Settings screen

Select the channels to appear on the waveform display.

(Default setting: All On)

Set the waveform display position and height for each channel as needed.

See "7.2 Setting the Screen Layout of the Waveform Screen (Sheet Set-

tings Screen)" and "7.3 Displaying Logic Waveforms" in the Instruction

Manual

Start Measurement