User Manual

4.2 Setting Procedure
81
3
4
Select the time axis range and recording length
Status Setting Screen (with memory function)
1 Press the SUB MENU keys to select the [Statu
s]
menu item.
2 (When using the memory function)
Press the
SHEET/PAGE keys to select the [Basi
c]
page.
3 (To record only logic inputs)
Use the CURSOR keys to move the cursor to [Tim
e
base], and press an F key to select the time per div
i-
sion for the horizontal axis.
(When the Timebase 2 is enabled [On], and only log
ic
inputs are assigned)
Set the sampling rate.
4 Use the CURSOR keys to move the cursor to [Sho
t]
(Recording Length), and press an F key to select th
e
number of divisions for the recording time.
About measurement configuration (timebase, recording
length, etc.)
See "Chapter 4 Measurement Configuration Settings" in
the Instruction Manual
1
2
3
Select the input channels
Channel Settings Screen
Probes
Logic Channels
1 Press the SUB MENU keys to select the [Channe
l]
menu item.
2 Press the SHEET/PAGE keys to select the [Logic
]
page.
The [Logic] page of the Channel Setting screen appears.
3 Use the CURSOR keys to move the cursor to th
e
Setting column for each probe (1 to 4) of the logi
c
channel, and press the F2 [On] key.
(On = display waveform, Off = do not display waveform)
To change a waveform’s color, move the cursor t
o
the waveform display color setting column an
d
select the color with the F1 or F2 key.
See "7.3.1 Setting the Waveform Display" in the
Instruction Manual
If you want to enter comments for individual
channels:
Select the [Comment] page.
See "5.2 Adding Comments" in the
Instruction Manual
1
2
(Default setting: [Off
])
Waveform Display
On/Off
Waveform Display
Color