Quick Start Guide

1.2 Measurement Workflow
12
1.2 Measurement Workflow
1 Install & Connect
Connect the instrument to the measurement object, an
d
turn power on.
See"Chapter 3 Measurement Preparations" (⇒ p. 37) in this manua
l
See"Instrument Installation" (⇒ p. 5) in this manual
Details of input module connections and connection cables:
See"Chapter 2 Connections" in the Input Module Guide
See"3.6 Turning the Power On and Off" (⇒ p. 46) in this manual
To set the clock:
See"3.7 Setting the Clock" (
⇒ p. 48)
2 Make Instrument Settings
Make appropriate instrument settings to acquire the mea
-
surement data.
See"Chapter 4 Basic Operations" (⇒ p. 49) in this manual, (Auto
-
matic setting is available (⇒ p. 51))
For details:
See"Chapter 4 Measurement Configuration Settings" in th
e
Instruction Manual
See"Chapter 3 Input Channel Settings" and "Chapter 4 Logic Inpu
t
Settings" in the Input Module Guide
See"Chapter 6 Trigger Settings" in the Instruction Manual
See"Chapter 7 Waveform Display Settings" in the Instruction Manua
l
See"Chapter 5 Saving & Loading Data" (⇒ p. 65) and "Chapter
6
Printing" (⇒ p. 75) in this manual,
"Chapter 10 Saving/Loading Data & Managing Files" and "Chap
-
ter 11 Printing" in the Instruction Manual
Turn power on
Setting measurement
configuration
Set trigger criteria
3 Measure
Install the instrument
Select the input channels
Start recording
Analysis
Optionally save and print
Press the START key to start measuring.
Measurement data is recorded by the instrument with the selected se
t-
tings.
Measurement data recording stops automatically after th
e
preset period, or when you press STOP.
(Setting contents determine what causes measurement to stop.)
Analyze measurement data (⇒ p. 61).
Save and print measurement data as occasion demands.
See"Chapter 8 Waveform Screen Monitoring and Analysis" in th
e
Instruction Manual, and Analysis Supplement
5 Finish
Connect
Stop recording
4 Analyze, Save and Print
Select the Screen Layout
Turn the power off
Set saving and printing
conditions
Overall workflow and summary
If you don’t want to shut down completely (in order to measur
e
again immediately), press the STANDBY/ON key to activate th
e
standby state (⇒ p. 47).
(To record specified waveforms)
(To change the layout of the Waveform screen)
(To automatically save and print while
measuring)
See"3.3.6 Starting and Stopping Measurement" in the Instructio
n
Manual
(As occasion demands)