Quick Start Guide

1.2 Measurement Workflow
18
Trigger Settings
(If you want to record a specific waveform, such as an
anomaly)
Make settings on the [Logic] page of the Trigger
Settings screen.
Press the SUB MENU keys to select the
menu
Press the SHEET/PAGE keys to select the
[Logic] page
6
Set the trigger mode
7
Set the trigger criteria (AND/ OR)
8
Set pre-trigger or trigger timing
9
Set the logic trigger
Display Sheet Settings
(If you want to change the display layout of the Wave-
form screen, to display any combination of waveforms)
Make settings on the [Logic] page of the Sheet Set-
tings screen.
Press the SUB MENU keys to select the
menu
Press the SHEET/PAGE keys to select the
[Logic] page
10
(As occasion demands)
Select the Screen Layout
Set the number screen divisions and
the split-screen layout
11
Select whether to display or not
12
Set display position
13
Set display height of recording
From here, proceed the same as for analog channels. Refer to "Saving Settings" (⇒ p. 15).
6
7
8
9
See"Chapter 6 Trigger Settings" and "6.8 Triggering b
y
Logic Signals (Logic Trigger)" in the Instruction Manual
Default setting:
[Auto]
Default setting:
[OR]
Default setting:
[Off]
12
11
13
10
See"7.3.2 Setting the Display Position" and "7.3.3 Settin
g
the Display Height" in the Instruction Manual
Default setting:
[On]
Default setting:
[Normal]