Quick Start Guide

2.1 Panel Names and Functions
21
This section provides an overview of the operating keys. Refer to "Chapter 2 Operating Keys and Screen
Contents" in the Instruction Manual for functional details of each key.
Operating Keys
*1. FN Mode
Functions differ according to the type of display screen. Refer to "Chapter 2 Operating Keys and Screen Contents" in th
e
Instruction Manual. (For the Waveform Screen)
F1: Switches numerical display. F5: Sets input channels.
F2: Switches displayed gauge. F6: Forces (Manual) triggering.
F3: Displays level monitor. F7: Searches the waveform.
F4: Executes auto setting. F8: (supported by upgrade)
Select setting items
CURSOR keys
: Moves among setting items
(Hold the left and right keys for three seconds to
activate the key-lock state. Hold again for three
seconds to cancel)
SELECT key: Accepts the selected character o
r
opens the pull-down menu
ENTER key: Accepts the setting
ESC key: Cancels an operation, closes a dialog
HELP/CONV key (supported by upgrade)
Set A/B cursors
TYPE key
: Cursor type
SPEED key: Speed of cursor motion
A/B knobs: Inner knob A moves cursor A, Oute
r
knob B moves cursor B
Print (⇒ p. 78)
PRINT key
Feed recording paper
FEED key
Paper feeds while pressing
the key.
Save (⇒ p. 71)
SAVE key
Select the Sheet (Waveform screen) or
Page (Settings screen)
SHEET/PAGE keys
Scroll waveform
SCROLL control
(Jog: inner, Shuttle: outer)
View waveforms
(Waveform Screen)
DISP key
Open Settings Screen
SET key
View a file on storage
media (File Screen)
FILE key
Toggle standby state (⇒ p. 47)
STANDBY/ON key
Change F key functions
FUNCTION MODE key
Select setting items
F1 to F8 keys
(Indicated as “F key” for ge-
neric reference)
Press the FUNCTION MODE
key to change the function
(FN mode)*
1
labels that ap-
pear below F1 to F8.
Selects menus
SUB MENU keys
Stop measurement
STOP key
1 press: Measurement stops after the set recording length,
2 presses: Immediate stop
Start measurement
START key
The green LED at the left is lit during measurement.
Select the input channels
UNIT key
: Module Unit selection
CH key: Channel selection
RANGE/POSN knobs:
Measurement range selection (RANGE knob: in-
ner)
Zero-position setting (POSN knob: outer)
Select the timebase
TIME/DIV key
(Input waveform acquisition rate)