Quick Start Guide

2.2 Screen Types and Contents
23
2.2 Screen Types and Contents
There are five general screen types. Refer to the Instruction Manual for details about each screen type.
Refer to the Analysis Supplement for details of the FFT function.
At power on, either the Opening screen or the Screen with the same settings that were in effect when powe
r
was last turned off appears.
Opening Screen
System Configuration
List
Configuration can be verified
on the System screen
Setting Items
Functions can be selected with the F
keys.
"Function Selection" (
⇒ p. 29)
The Waveform screen appears
when you select a function.
SET key FILE key
To File Screen
(
⇒ p. 28)
To Settings Screen
(
⇒ p. 24)
To Waveform Screen
Function Menu
Select a function before mea-
suring (
⇒ p. 29).
(Functions can be changed
from the Waveform or Settings
screens)
This screen appears first after power on. (When you turn the power off with the Waveform screen dis-
played, it reappears after this screen.) The boot process takes about 40 seconds.
Load existing data
Make settingsView waveforms
DISP key
For details of screen contents:"2.3 Opening Screen" in the Instruction Manual
To System Screen
(
⇒ p. 27)
Press the F7 key, or
hold down the
SET key
Waveform Screen
Press the DISP key.
DISP
Displays waveforms acquired by the instrument. Waveforms can be displayed on separate sheets, or as
the numerical values or an X-Y composite.
Record Data (⇒ p. 30)
Press the SHEET/PAGE keys
to change the displayed sheet.
Status bar (⇒ p. 30)
Function Menu
To change functions
(
⇒ p. 51)
Scroll bar (
⇒ p. 30)
For details of screen contents: "2.4 Waveform Screen" in the Instruction Manual
Setting items (⇒ p. 31)
Press the SUB MENU keys to
switch which setting items are dis-
played.
Press the F keys (
F1 to F8) to select
a specific setting.
(⇒ p. 32)
Clock (⇒ p. 48)
Shows the current time.
The FUNCTION MODE key
changes the functions of the F1 to F8
keys.
[MACRO][SET] [FN]