Quick Start Guide
2.3 Basic Operations
35
Press the DISP key. The recorded waveform appears on the Waveform screen.
For analysis procedures, refer to "9. Analyze Data" (ā p. 61), or "Chapter 8
Waveform Screen Monitoring and Analysis" in the Instruction Manual.
See "8.1 Scrolling Waveforms" in the Instruction Manual
Turn the inner (Jog) or outer (Shuttle) knobs of the SCROLL control to scroll the
waveform display. (only when the recorded length is at least 25 divisions)
You can reverse the Jog and Shuttle scroll directions.
See "12.2.3 Specifying Jog & Shuttle Scroll Operations" in the Instruction Manual
The waveform scroll direction can be indicated vertically or continuously.
See "7.2.5 Setting Waveform Scrolling Orientation" in the Instruction Manual
To increase the scrolling speed:
The scroll speed is controlled by the degree of rotation of the outer Shuttle knob.
Turning the knob more increases the scrolling speed.
To scroll automatically (Auto-Scroll):
Turn the outer Shuttle knob in the direction desired to scroll the waveform, hold it
until āAuto-Scrollā appears on the screen, and release it.
When the Shuttle knob is released, the waveform continues to scroll automati-
cally.
To cancel, press any operating key.
See "8.8 Cursor Values" in the Instruction Manual
Press the TYPE key and set an A/B cursor using the Settings dialog. Turn inner
knob A or outer knob B to move the A/B cursors on the screen to confirm the
value at a cursor.
2.3.3 Viewing Recorded Data
Jog
Shuttle
Scrolling Waveforms
Turn CW
Scrolls later on the waveform
from the current point.
Turn CCW
Scrolls earlier on the waveform
from the current point.
Screen Display
Scroll Direction
Earlier Later
Knob A
Knob B
Confirming Measured Values