Quick Start Guide

3.1 Installation & Connection Procedures
37
Be sure to read the "Operating Precautions" (⇒ p. 5) before installing and connecting this
instrument.
Measurement
Preparations Chapter 3
3.1 Installation & Connection Procedures
Install this instrument
(
⇒ p. 5)
1
(When adding or changing an input module)
Install an input module
Refer to the Input Module Guide.
3
Which probes and cables to connect depends o
n
your measurement application (⇒ p. 38).
Refer to the Input Module Guide for details.
4
(When printing)
Load recording paper
(
⇒ p. 42)
7
Connect the power cord
(
⇒ p. 45)
(When measuring in an elec-
trically noisy environment)
Ground the Functional
Earth of this instru-
ment (
⇒ p. 45)
Turn the power on
(
⇒ p. 46)
When finished measuring, disconnect the
cable(s) from the measurement object(s),
and turn the power off.
Left Side
Right Side
Connect the inpu
t
cable(s) to the
input module
Connect a logic
probe to the
LOGIC receptacle
(When measuring
analog signals)
(When measuring
logic signals)
Top Panel
6
7
GND
2
POWER
5
6
Other Connections
To use a PS/2 mouse, connect it before turning the power on
.
See "3.2.2 Using a Mouse" and "3.3.4 Mouse Operations" in the Instruction Manual
• If the clock is wrong after turning power on: "3.7 Setting the Clock" (
⇒ p. 48)
• When using a PC Card: "5.2 Using PC Cards" (
⇒ p. 67)
• When using other storage media or drives: "10.1 Storage Media" in the Instruction Manual
• When using a keyboard: "3.2.3 Using a Keyboard" in the Instruction Manual