Quick Start Guide

3.2 Connecting Cables and Probes
40
Applicable Input Modules
• Model 8937 Voltage/Temp Unit
• Model 8958 16-Ch Scanner Unit
Use to connect: Thermocouple
Thermocouple
For the Model 8937 Voltage/Temp
Unit
(Compatible wire: AWG 16 to 26, 0.4
to 1.2 mm diameter)
For the Model 8958 16-Ch Scanner
Unit
(Compatible wire: AWG 16 to 26,
0.14 to 1.5 mm
2
)
Connect to terminal block
Connect to terminal block
Measuring Temperature
Connect to the terminal block on the input
module.
Connection Procedure:
"2.2.3 Connecting to the Model 8937 Volt-
age/Temp Unit" and "2.2.7 Connecting to
the Model 8958 16-Ch Scanner Unit" in the
Input Module Guide
Applicable Input Modules
Model 8940 F/V Unit
Use to connect: Connection Cable
Model 9198 Connection Cord
(Maximum input voltage: 300 V)
Small alligator clip type
Measuring Frequency, Count and Pulse Duty
Connect to the BNC jack on an input mod-
ule.
Connection Procedure:
"2.2.5 Connecting to the Model 8940 F/V
Unit" in the Input Module Guide
Applicable Input Modules
• Model 8939 Strain Unit
• Model 8960 Strain Unit
Use to connect: Sensor
Strain Gauge Transducer
(Not available from Hioki)
Example:
Connecting using a conve
r-
sion cable
Using a Strain Gauge to Measure Vibration or Displacement (Strain)
Connect to the BNC jack on an input mod-
ule.
Connection Procedure:
"2.2.4 Connecting to a Strain Unit (Models
8939 and 8960)" in the Input Module Guide
Use the conversion cable supplied with the
input module according to the sensor be-
ing used.